Power Supply Transformer 220V AC/DC 2A 12V

Waterproof Electronic ABS Plastic Junction Prototype Box 115x90x55 features:
- Excellent waterproof performance and moisture proof
- Dimension 115x90x55 mm

This connector can be used in most modeling projects.
It is ideal for small Lipo and NiMH connection. JST Male Connector 15cm AWG18 features:
- Type: JST male connector for RC BEC Lipo
- Color:
- Black: low power polarity
- Red: high power polarity
- Length: 20cm

40x Female-Female Cable 20cm features:
-Length: 20cm
-Quantity: 40 wires
-Dupont female connectors on both ends
-Compatible with 2.54mm male connectors
-High quality and good working condition
-Easy to install and use

This module includes the BMP280 component that converts atmospheric pressure, temperature and humidity with high precision into a digital signal.
The equipment uses the two I2C and SPI interfaces. The very good measurements made by the BMP280 allows the module to be used as an altimeter.
Its 5-pin straight connector allows easy connection to other electronic boards. BMP280 Temperature Barometric Pressure Sensor Module/SPI features:
- Interfaces:
       -I2C (up to 3.4 MHz)
       -SPI (up to 10 MHz)
- Supply voltage: 1.8-5VDC
- Module operating range:
       - Temperature: -40ºC to + 85ºC
0-100%
       - Pressure: 300-1100 hPa
- Resolution of the measures:
       - Temperature: 0.01ºC

Black U-shaped servo motor mounting bracket for MG995 and MG996 servo motors. Ideal for robot arms or creating your own structures. Includes hardware.

NodeMcu module based on ESP8266 controller and programming in Lua language
NodeMcu is equipped with 10 GPIO, PWM, I2C, 1-wire and ADC
ESP8266-12E is an improved version of ESP8266-12
It works as a standard WiFi 802.11 b / g / n 2.4 GHz
USB Communication - CP2102 Chip
Characteristic:
ESP 12E ESP8266 ESP12E NodeMcu Lua Wireless Development Board CP2102 WiFi features:

- Supply voltage: 3.3V (LOGICAL LEVELS: 3.3V)
- Supported protocols: 802.11 b / g / n
- Network support: 2.4 GHz
- Band: 2400 (MHz) - Wi-Fi Direct (P2p), Soft Access Point
- Integrated TCP / IP stack
- PLL, regulators and integrated power management units
- Output power: 0 , 15 (W); + 19.5dBm in 802.11b mode

Prototype Board MB-102 Protoboard 830 points Arduino features:
- 830 Connections
- Linkable with other boards
- Base with adhesive to attach it to the work surface
- Measures 165x 55x8mm

10x Electrolytic Capacitor 100 uF 25V 105ºC Arduino features:
-Type: Electrolytic Capacitor
-Assembly: intern
-Value: 100uF
-Maximum tension: 25V
-Maximum temperature: 105º C
-Dimensions: 6x11mm
-Quantity: 10 units