Mini Soldering Iron Stand

1N4007 Rectifier Diodes 1A 1000V DO-41 features:
- Standard rectifier diode
- Configuration: Simple
- Reverse voltage: 1000V
- Direct voltage drop: 1V
- Direct direct current: 1A
- Maximum overvoltage current: 30A
- Encapsulated: DO-41
- Operational tension: -65ºC to + 125ºC
- Quantity: 30 units

Flux Solder Paste in Tin Can 100g features:
- Welding paste according to DIN EN 29454-1 1.1.2.C.
- Flux paste based on medium activity rosin.
- Easy to solder: copper, silver plated, zinc and nickel. Flux residues after welding do not cause corrosion of non-ferrous metals and may remain in the joints.
Operating temperature of up to 350 C.

Resistors 6,8K Ohm 5% 0,25W 1/4W features:
- 6.8 Ohm
-Type: Carbon film
-Tolerance: ±5%
-Power: 0.25W
-Dimensions: 2x7mm

Digispark is a development board based on the ATTINY85 microcontroller from ATMEL born in a successful campaign on Kickstarter.
Similar to the Arduino line , It is one of the smallest boards on the market.
Programmable directly from USB with the same Arduino tools. It has a built-in Micronucleus bootloader and can be replaced by similar ones such as the Trinket bootloader. Adafruit or others.
You can use many of the same Arduino libraries and you have your own on the digispark wiki. Arduino compatible Attiny85 Digispark board features:
- USB power supply
- External power supply (7v-35v DC 12v maximum recommended)
- 5V DC 500mA regulator on board
- Programmable with the Arduino IDE
- Loaded with Micronucleus bootloader

Jack connectors 2.1mm inside and 5.5mm outside to power devices such as LED strips, CCTV (Cameras), Arduino. Connector Jack 2.1x5.5mm Power Supply DC Male features:
- Ideal for connecting without welding
- It has two screws in the tip for positive and negative cable screwdriver

Third hand stand for easy soldering of wires with a diameter from 1 to 5mm. Number of holes 5.

Power Supply Transformer 220V AC/DC 1A 5V features:
- Input voltage: 100~240V 50Hz
- Output voltage: DC 5V
- Output current: 1A
- DC connector: 5.5 mm x 2.1 mm
- Cable length: Approx. 90 cm
- Indicator of operation: LED diode

- It has an Atmega328P chip running at 16Mhz with a factory loaded bootloader - The Uno R3 module has all the connectors than the Arduino Uno R3 and is compatible with all Arduino shields Arduino compatible UNO R3 board features:
- Includes USB Cable - ATmega328P 16MHz chip with external quartz crystal
- Microprocessor: ATmega328
- Operating voltage: 5V
- Input voltage (recommended): 7-12V
- Input voltage (limits): 6-20V
- Clock speed: 16 MHz
- Digital I / O Pins: 14
- Analog input pins: 6
- DC current per I / O Pin: 40 mA
- DC Current per Pin 3.3V: 50 mA
- Flash32 KB of which 0.5 KB are used by the bootloader - Atmega328
- SRAM 2 KB - Atmega328