Car Robot Tire Wheel Smart Car

Resistor 220 Ohm 5% 0,25W 1/4W features:
-220 Ohm
-Type: Carbon film
-Tolerance: ±5%
-Power: 0.25W
-Dimensions: 2x7mm

USB Cable for Arduino Type A-B features:
- Length: 50cm
- Color: Blue

3x DC PCB Socket Connector 5.5 x 2.1 features:
- Type: DC female jack
- Diameter of the pin: 2,1mm
- Diameter of the connector: 5.5mm
- Quantity: 3 units

Robot arm set 4 DOF acrylic with screws and screwdriver for robotics projects.
100% compatible with Arduino.
Acrylic robot 4 DOF Arm without servo features:
- Type: DIY kit robot arm 4 DOF
- Degree: 4 degrees of freedom
- Material: acrylic
- For: 8 years and above
- Weight: ~ 450 g
- Does not include servos but it is imperative to have 4 micro servos sg90 to be able to mount it
More informations:
1. 4 arm axes with more untrammeled and flexible experience.
2. Most of the pieces are integrated in a perforated way at a time, which is very strong and easy to install.
3. All movement joints are using high quality bearings with good precision.

20 Mini Jumpers 2.54mm Short Circuit Board PCB features:
- Mini standard 2.54mm jumpers for making short circuit bridges on printed circuit boards, hard disks, PCBs, etc.

Gear Reducer Motor 6V DC 200RPM for Smart Car features:
- Voltage: 3 to 6V DC
- Speed without load: 200 RPM to 6V DC
Helpful Links:
Operation of the robot by Infrared / Operation of the robot by Bluetooth / Automatic operation with detection of obstacles
- Wiring of the 6V DC 200 RPM motor with the L298N double bridge H controller module

A set of flat drive belts with a diameter from 27mm to 80mm. The kit includes approximately 50 pieces of strips from 0.5 mm to 1 mm thick.
Technical data:
- width: 2.0mm
- diameter from 27mm to 80mm
- thickness: from 0.5 to 1mm
Quantity tolerance +/- 5%

- It has an Atmega328P chip running at 16Mhz with a factory loaded bootloader - The Uno R3 module has all the connectors than the Arduino Uno R3 and is compatible with all Arduino shields Arduino compatible UNO R3 board features:
- Includes USB Cable - ATmega328P 16MHz chip with external quartz crystal
- Microprocessor: ATmega328
- Operating voltage: 5V
- Input voltage (recommended): 7-12V
- Input voltage (limits): 6-20V
- Clock speed: 16 MHz
- Digital I / O Pins: 14
- Analog input pins: 6
- DC current per I / O Pin: 40 mA
- DC Current per Pin 3.3V: 50 mA
- Flash32 KB of which 0.5 KB are used by the bootloader - Atmega328
- SRAM 2 KB - Atmega328